About mscomms

mscomms · 10-22-2009

Hi There I am trying to configure a tunnel to carry CLNS traffic using the following configinterface Tunnel0 description *** OSI Tunnel to Langley *** no ip address clns router isis isis metric 21 level-1 tunnel source Loopback0 tunnel destination xx...

mscomms · 10-23-2009

I tried 1 early on to no effect but I had noticed that it was running IPBASE as well and have just upgraded to ENTBASE and it now accepts the command, Thanks for your helpMike

mscomms · 10-23-2009

Here is the sh hardPENNER-DCNKR-02#sh hardCisco IOS Software, 3800 Software (C3825-IPBASE-M), Version 12.4(15)T7, RELEASESOFTWARE (fc3)Technical Support: http://www.cisco.com/techsupportCopyright (c) 1986-2008 by Cisco Systems, Inc.Compiled Wed 13-Au...

mscomms · 10-23-2009

PENNER-DCNKR-02(config)#int tun 0PENNER-DCNKR-02(config-if)#desc *** OSI tunnel to HX89 ***PENNER-DCNKR-02(config-if)#clns router isisPENNER-DCNKR-02(config-if)#isis metric 21 level-1PENNER-DCNKR-02(config-if)#tun source lo0PENNER-DCNKR-02(config-if)...

mscomms · 10-22-2009

I could give that a try and I will if I do net get a resolution but I have 15 - 20 of these tunnels and i would like to keep them standard.

mscomms · 10-22-2009

from an enable prompt trysh snmp mib | inc ciscoMgmtlook for ciscoMgmt.84If this is missing then the ciscoIpStat mib is not available on the router

Member Since	‎10-22-2009 08:12 AM
Date Last Visited	‎08-18-2017 03:54 AM
Posts	6

User Statistics

User Activity

Mode change not accepted

Re: Mode change not accepted

Re: Mode change not accepted

Re: Mode change not accepted

Re: Mode change not accepted

Re: snmp response