Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have 2 EWDM muxes in a lab and would like to set up a test connection over X2-10 GBics. I have 10 db attenuators which I could connect on RX end or on both both the TX & RX ends avoid any damage.Question: Due to the distance being short, could this...
Hi,I would like to disable the current activation-key on the PIX before disposing it off. Is it possible to remove the key. There are a lot of posts how to add the key, but did not find any on removing.Thanks
I have 2 routers connected, can ping each other on the F0/0 interfaces. Each has loopback interfaces which are the only once advertised in BGP (AS1).Problem: I am not able to ping the loopback addresses.Any ideas. This should be possible.Config:route...
Thanks GuysWhat I would like to achieve is the second option given by "mikedavi1"I have removed "update-source loopback 0"But I still cannot ping both ends via the loopback interfaces.R2#sh run | begin bgprouter bgp 1 synchronization bgp log-neighbor...
