Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I've been getting warning messages from the event log of a 1300 series bridge, which is set as an Access Point in the network, states: 'Packet to client (mac address) reached max retries, removing the client'; I'm not sure why the client is removed....
Device: Cisco AIR AP1240 Switch configured as a Bridge that is connected and associates with AP's in a WLAN.Question: What is the significance of the Virtual-Dot11 Radio' s associated with the device? For example, virtual-dot11radio3.
HARDWARE/ISSUE: AIRONET AP1240 which has a 2.4 GHz/ 5 GHz radios and is configured to be used as a access point for radio0 and non-root bridge for radio1 using Right instead of Diversity as its primary connections for the radios, but it would not all...
I don't understand why I should switch both radio configurations? I monitor several AP's that have the same config as the one I'm having issues with. These AP's radio status are up and they provide adequate wireless signals within their designated a...
Also, should the config line 'payload encapsulation dot1h' be removed since it does not appear in the radio0 configuration?? What is the significance of this line in radio1?
Radio0 station role is an access point and Radio1 station role is a non-root bridge. That's why Radio1 configuration is 'station role non-root', but as for the config 'payload encapsulation dot1h', should this config be 'payload encapsulation dot11'...
