Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I get this error when installing the SCC Toolbar:"CIsco Unified CME Telephone Service Provider is detected in your system. This product is not compatible with Smart CallConnector. Please uninstall it and try to install Smart CallConnector again."I'm ...
Shtalukd,Strange thing is, I don't have nor have ever had CME TSP installed, and it doesn't show up in Control Panel, or under Phone and modems. I checked in the installer clean up and it's not there either.
Thanks for the responses. I figured out the solution later last week and didn't get a chance to come update the post yet.All I had to do was go into PSTN Trunks, go into each individual FXO port and uncheck the box to Enable Battery Reversal. That si...
Hello,Did you ever find a solution to this problem? I have two UC540's connecting to AT&T POTS lines in two separate locations that see the exact same issue. You can even watch the front of the UC where the line is plugged in light up on the first ri...
