I configured ISAKMP-IPSEC on my tunnel but I see no evidence of it functioning. The tunnel works fine. A traceroute shows 1 hop even though the two routers are physically separated by one router and two non-contiguous networks. There is simply no evi...
Yes. It just took some line-by-line research so I could finally understand what each phase is and what it does. I am running EIGRP, and I did finally get ISAKMP to come up. Thanks again for your help.
Thank you again! Unfortunately there is no menu choice for keepalive on int tunnel 1. I also tried int g0/0/0 which is the physical interface for that end of the tunnel. There is nothing called keepalive there either. All I have is the following:===...
Thank you! I made the correction. But still nothing and debug shows nothing even though I enabled debug ISAKMP and IPSec.Here is the sh crypto isakmp sa on Router1. Router2 shows the same.=====================================================Router1#s...
Hi. Thank you for the help. Unfortunately I am still not getting any interesting traffic. Everything else works though and I am now getting a new message from sh run. This is what I have: Router1 / R1 Tunnel logical source: 170.156.45.1 / Tunnel phy...
