Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear all,I have a question about configuration of a Catalyst 6500 with Sup2/MSFC2+PFC2When configuring a Vlan Interface for Routing the VLAN, which is the best config (see below)?Config 1:interface Vlan<X> ip address <ip_address> <Subnet_Mask> no...
Hi,We use CW2000 LMS 2.2 with last IDU (8.0) installed.When checking devices attributes for Catalyst 6500 (Sup1 with CatOS 7.6(5)), it is impossible to have a correct telnet access.We want to use network show command but it is impossible for Catalyst...
HelloWe just finished installation of a new CiscoWorks LMS 2.2.We have a problem with jobs. The "jrm" process start and directly stop.In the jrm log, we found following messages :07/09/2004 09:55:18 Exception occured, exitingFATAL ERROR : Can not con...
Hello,We have a NAM1 (SVC-NAM-1) software version 3.1(1a) - Maintenance Image 1.1 into a Catalyst 6506 (Native IOS 12.1(13)E6)After a feew weeks running, NAM is no more reachable with Telnet or HTTP but :Ping of NAM IP adress repliesShow module on C...
Hello,I have a simpleconfiguration :One-Armed CSS 11503.VIP and servers in the same subnet (10.1.160.0/22)One VIP adress : 10.1.163.172One content tcp on port 90 (access to an URL : http://10.1.163.172:90/check.html)2 servers : 10.1.160.172 and 10.1....
