Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am trying to setup a connection to a remote non domain workstation that is behind an unmanaged router.My routes aren't working and any help would be greatly appreciated.The SVI for VLAN 163 in on router 3The gateway for the 92 network is on the unm...
Is there a way on a layer 3 device with multiple IP addresses on it to determine what the logging source-interface is set to? I need to go through and verify settings. Besides just going and running the command on everything I was hoping there was a ...
The question here is we have a cisco 9200 that is doing our routing. When I plug in a printer into the 9200 with IP configured you are able to get to the IP address with no issue. When the printer is then taken to a Catalyst 1000 you are unable to ge...
I am working on creating ACL to lock down our VLANs. I am running into some issue though. These are outbound ACL'sHere is my ACLip access-list extended veneer-75remark permit KaceSMA agent accesspermit tcp host 192.168.210.70 10.2.75.0 0.0.0.255 eq 4...
I have the following ACL. For the most part everything is working in the ACL as it should be. The problem is that even though 192.168.203.0 is permitted, I still get denies in the logs. The logs will be below the ACL. We switched from TCP to IP in th...
I also know that the route out works as we were using a different solution before that had to be routed out. My issue now is that I am trying to gain access in first.
Printer is being attached to the same port on the 9200 when it is working and when it is not working. We don't have any ACL's specific to that VLAN. We have verified that the VLAN isn't being pruned by STP. It is odd that it will work but when connec...
