Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi BillI believe you are using a cross cable between the FXO FXS interfaces at this moment. Use a straight cable between FXO and FXS interface and it will work fine.
Hi TedI would strongly suggest to enable ip inspect commands. Since you have Exchange Server running esmtp, you need to enable ip inspect esmtp command which was introduced in 12.3(7)T. SMTP/ESMTP cannot coexist. Disable SMTP and enable esmtp. ES...
Yes. It is possible to have a pair of ASA in transparent mode with LAN based Active/Standy failover. You should do the failover configuration after converting the appliance into transparent mode.I haven't seen any example on cisco site, but I will ...
Can you check this linkhttp://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_tech_note09186a00804c8b9f.shtmlMight be you are bumping in to this issue.
