About todjohns

todjohns · 09-13-2011

I have several UCS C210 M1 and M2s, each has 5 x drives installed (72 gb). I interrupt the boot process via cntrl-c to configure the LSI 1064E RAID controller but it's only showing 4 of the 5 installed drives. I can see all 5 drives via the CIMC i...

todjohns · 08-29-2011

I have several UCS C210 M1 servers that have just one power supply, I need to install a second one. Will I need to shut down the servers to install the second power supply?I found details on installing them here...http://www.cisco.com/en/US/docs/un...

todjohns · 09-15-2011

Thanks Dan, will get some eyes on the servers and see if they have either of the daughter cards you point out. I'm thinking that they don't since the drives are in bays 1 - 5 and I can only see 4 of them when in the LSI 1064e configuration utility.

todjohns · 09-14-2011

Apparently 4 drives is max that the LSI 1064E supports..."LSI 1064E-based mezzanine card (Large Form Factor server only, PID R200-1120402W). This card provides RAID 0, 1, and 1E support for up to four SAS or SATA drives" The above statement was pulle...

Member Since	‎08-29-2011 01:34 PM
Date Last Visited	‎08-18-2017 03:54 AM
Posts	4

User Statistics

User Activity

C210 M1/M2 LSI 1064E only seeing 4 of 5 drives

installing 2nd power supply in C210 M1 - downtime needed ?

C210 M1/M2 LSI 1064E only seeing 4 of 5 drives

C210 M1/M2 LSI 1064E only seeing 4 of 5 drives