Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello!I have CISCO 7206 router with NPE-G2 and 2 gig of memory.There's a vpn and pppoe servers on this unit and it hold maximum of 250-300 simultaneous connections. Periodically (1-5 times/hour) router suddenly reboots with lots of messages in consol...
Good time of day!I've planning to manage my existing wireless network with WLC. I have a WLC 4402 with 4 (yet) registered 1310 AP's on it. AP's have statically assigned IP's and there's no problems with their registration on controller. The problem ...
This ACL applies to Vitrual template interface (pptp, pppoe) and i suspect flood is going through netflow, but cannot determine which port exactly is generating this flood.
After long ivestigation my problem i've found that router crashes due to high CPU utilisation, which is likely caused by security issue (worms, viruses, etc.) I've applied ACL to interfaces, trying to deny most commonly used by worms ports, and it he...
Wireless clients that have integrated wireless cards (PCI or USB) get addresses, but, if wireless device is external (e.g Dlink-2100, or Zcom or Linksys or Zyxel), wired client attached to that device does not get address, while wireless device itsel...
Good time of day, Nathan.My WLC is running Product Version 5.2.157.0I've set up internal DHCP scope as you said (without activating) and still no luck. Also i tried to activate it, and there's same issue: clients with integrated WiFi cards works like...
