About EngineeringAir

EngineeringAir · 12-07-2021

All, I have a switch that has the correct IOS image and its brand new from the box. It booted properly and I unplugged it, racked it and it goes into ROMMON. When I initiate the boot flash:packages.conf command it boots properly but when I reboot th...

EngineeringAir · 09-28-2021

Hi Cisco Community, I am hoping someone can help me out. Myself and another Engineer have run multiple tests on the ASA and have come up empty. We have an ACL that allows traffic between two servers on two different networks. When we attempt to pas...

EngineeringAir · 12-07-2021

Hi Reza, That worked, thank you.I've been going crazy. All the best, E

EngineeringAir · 09-30-2021

Hi Chakshu, Those are not the interfaces, they are just the two endpoints. Is there a specific route you would like me to look at? The Static Routes we have should route between the two networks. Thanks, E

EngineeringAir · 09-30-2021

Hi Marius, Here is the Output of Run, I have removed any unnecessary configuration. Interface Server_DMZ 10.10.10.1Interface Inside 84.1.1.1!interface GigabitEthernet0/1description Insidenameif Insidesecurity-level 100ip address 84.1.1.212 255.0.0.0 ...

EngineeringAir · 09-30-2021

Hi Chakshu, Here is the updated packet-tracer. Firewall01# packet-tracer input Inside icmp 10.10.10.1 8 0 84.1.1.1 detailedPhase: 1Type: ROUTE-LOOKUPSubtype: Resolve Egress InterfaceResult: ALLOWConfig:Additional Information:found next-hop 84.1.1.1 u...

EngineeringAir · 09-30-2021

Hi Chakshu, Here is the updated packet tracer. pri/act/Firewall01# packet-tracer input Inside icmp 84.1.1.1 8 0 10.10.10.1detailedPhase: 1Type: UN-NATSubtype: staticResult: ALLOWConfig:nat (Inside,Server_DMZ) source static Netmon.84.1.1.1 netmon.nat...

Member Since	‎09-28-2021 05:27 AM
Date Last Visited	‎02-15-2022 12:14 PM
Posts	9

User Statistics

User Activity

Cisco Catalyst 9300 Boot

ASA ACL Blocking

Re: Cisco Catalyst 9300 Boot

Re: ASA ACL Blocking

Re: ASA ACL Blocking

Re: ASA ACL Blocking

Re: ASA ACL Blocking