I have created a community in cisco assistant software. When adding a 2960x switch, it is seen as a “neighbor” in topology map, but unable to join the neighborhood.  This over a closed Metro E network, all switches on the same subnet.  When managing ...

Good Evening   Using Cisco Assistant Software v 6.3, none of the ports in use are showing active (Though the status in the web interface does for the switch itself) all of the ports are dark, with exception of STAT led is showing Green   Is there a f...

Hello again I posted a similar question regarding VTP a week ago I have 11 switches in a metro fiber network , 2950s.  I added two switches after copying a similar config from switches on this network, along with their existing vlan information. The...