Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, I own a C9115 with EWC and would like to configure a DFS channel thru the web interface. I've only 2 choices for the configuration on AP 5GHz1) Custom -> Manually select channel (non DFS channels)2) Global -> Automated channel selection but on...
Hello, My C9115 with EWC was working fine and after a power outage no more SSID broadcasted and remote web administration no more accessible. The IP address was even not possible to ping.After a full reset with the mode button, I try to do again the ...
Yes exact, it's needed to wait 1 minute for the DFS frequency scan (in case of radar is already transmitted on the same freq.). But even after several minutes I still couldn't see the requested frequency.I finally found the solution. It's needed to s...
Hi, I created a new RF profile and RF tag assigned in the AP but still the same. When I edit the 5GHz radio I still see the channel 36 that should not be present anymore.See below the screenshots of my setup. Please tell me if I did something wrong.1...
Hi Arshad,Actually I did the factory reset but didn't change the fact that I still couldn't connect to the Web interface after setting an IP address (of my local NW) on the GigabitEthernet0 interface. Actually I forgot that after a full reset the AP ...
Hi,There's no other WLC on the same LAN. This AP is connected on it's own switch with other equipment but no AP.BTW, I could get rid of the previous error (Failed to save vrrp-ip.txt) by issuing the command "write erase" seen in another thread here.I...
