Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,Could you please confirm whether the "SFP+ 10GBASE-T" transceiver is compatible with the port shown below?Thanks!Model: N9K-C93180YC-FXType (SFP capable): 10Gbase-(unknown)Speed: 100,1000,10000,25000Duplex: fullTrunk encap. type: 802.1QChannel:...
Hi! Why I can't see the route from CE on PE in VPN_CUST_B?PE:
ip vrf VPN_CUST_A
rd 1:1
route-target export 100:100
route-target import 100:100
!
ip vrf VPN_CUST_B
rd 2:2
route-target export 200:200
route-target import 200:200
!
interface Loopba...
Hi! I see the prefixes from R4 on R1 and the prefixes from R1 in R4 but I can't ping from R1 to the prefixes from R4 and vice versa. Why? Where am I wrong? I attached photo with network. Thanks!CiscoLinuxBase-4:
Router#show ip bgp
BGP table version i...
Hi! How can I configure this network to have ping from CiscoLinuxBased-2/CiscoLinuxBased-3/CiscoLinuxBased-4 in Ubuntu?I configured ospf between routers and I also advertise 192.168.107.0/24 in ospf on CiscoLinuxBased-1.I attached 2 photos.This is th...
Hi!I have an issue, how can I apply template rr-policy to a neighbor session? I don't have any optionP0#show versionCisco IOS Software, IOSv Software (VIOS-ADVENTERPRISEK9-M), Version 15.6(2)T, RELEASE SOFTWARE (fc2)Technical Support: http://www.cisc...
Hello,I need to connect a 10Gb copper cable. I searched through the file, but I couldn't find any 10Gb copper SFPs. I have attached a photo. Does a 10Gb copper SFP exist?Thanks!
I attached the photo.It works, but why? In CEF it's the same thing with network and redistribute.@MHM Cisco World wrote:there is no attachment and for ping try use redisturbte connected under bgp and check MHMRouter(config)#router bgp 123Router(confi...
Here:CiscoLinuxBased-1#show ip ospf neighborNeighbor ID Pri State Dead Time Address Interface10.0.0.14 1 FULL/BDR 00:00:36 10.0.0.14 GigabitEthernet0/110.0.0.5 1 FULL/BDR 00:00:38 10.0.0.2 GigabitEthernet0/2CiscoLinuxBased-2#show ip ospf neighborNeig...
I modified that network on CiscoLinuxBased-4I received the route 192.168.107.0 on all routers, I have from all routers in 192.168.107.139. 192.168.107.137 is on CiscoLinuxBased-1 (int g0/0), but 192.168.107.139 does not respond to ping.How can I con...
