Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have an AP541N connected to a SA540 router. I have several computers that connect wirelessly including Apple iTouches and a PS3. I am using WPA personnel with WPA2/AES checked in the configuration. I do not broadcast the SSID but each computer h...
I noticed that there was a new firmware upgrade available for the SA540 router. From reading the release notes it appears that the new upgrade will reset the router to factory defaults and the recommended upgrade is to print off the pages that willl...
Is it possible for a home user to use theTrendeMicro ProtectLink service with a SA540 without setting up an email server? I am using this router in my home with Verizon FIOS with their email. If it is possible could I please get instructions on how...
I would like to set up my ASA 5505 with one switch port port used for my wireless access point and the others set up for my home network. I do not want the WAP to be able to communication with the other inside home computers. I have set up the foll...
Any further update on this firmware upgrade issue?I just received my AP541N and would like to upgrade to the mentioned 1.8.0 firmware upgrade. When I go into the AP541 management interface and click on the link to upgrade the software it brings me t...
Steve,Thanks for the quick replies. I do own several domain names and maybe I can work with my domain registars and see if they can do something as far as pointing the MX record and making the TrenMicro solution work and using email from them..Greg
I am still confused. Below is the system requirements from the CISCO PDF file. From reading other information on the TrendMicro ProtectLink there is discussion of redirecting the email etc. via the MX record which I do not have the capability to do ...
But what if I want to also use the email screening service of the ProtectLink? Is that possible under my existing setup? If not what would be the simpliest way to add to my current setup to allow for the email screening.Thanks in advance,Greg
I took a look at the referenced link. In the end I used the wizard to setup the 3 VLANS and then just added a NAT rule to allow the Wireless Access Point VLAN to the outside interface. I set the security level of both the inside home and the wap to...
