Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Ok I just config'd a switch: a WS-C3750G-48PS-S I'm using C3750-IPBASEK9-M SW Version: 12.2(55)SE11
I put the config on and shipped it out to the site. The Switch came right up. I was able to remote in. Initially it was on a port channel. I have sinc...
Community. I'm scratching my head. I've put all details in a PDF attached. Basically I've got IPSEC B2B tunnel (working) I'm slipping a GRE tunnel through it and it's working (partially) I can ping on one side and not the other. At first I thought he...
First of all. Thanks to everybody who had input on this post. Everyone had great input!
The problem ended up being What Andy suggested. I set up a dummy dot1q sub-if on my router with vlan tag 33. I set up vlan 33 on my switch running vtp server. I c...
My upstream switch, the 3650.. I'm wondering if snooping is causing a problem? This is the c3650 snooping output:MASW01#sh ip dhcp snoopingSwitch DHCP snooping is disabledDHCP snooping is configured on following VLANs:noneDHCP snooping is operational...
Greetings. I found out today though TAC that ASA's don't support GRE through the IPSEC tunnel.
In order to solve the need, I set up the ASA to do a 1:1 nat from a public IP to a loopback on the remote router. I set up a similar config on a router on ...
After researching this a and doing some extensive reading I believe that possibly the IPSEC transform set is in "Default tunnel" mode on the ASA side and not in "transport" mode which I see seems to be necessary to transport GRE over ipsec with an AS...
Yes ahmedshoaib thanks for pointing that out. You are correct I incorrectly labeled REMOTE B Lo0.
It shoud be as you say, 192.168.2.218. I fear the same. I have confirmed the Palo Alto is allowing traffic to and from. I have full visibility to verify...
