Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I am trying to setup a Cisco C9800 LC and I'm getting stuck in the very beginning on the Day-0 config.Tutorials and manuals state I should be able to receive an IP address from the device and then be able to access it via browser. No IP address...
Hi,I have created a test setup in a verification lab.Cisco 2504 Controller (v. 8.3.143.0) The configuration to enable 802.11r seems straight forward. Problem:The device I want to test (supports 802.11 k/v/r) connects just fine when I use FT 802.1x in...
Yes, that is what I used after attempting to connect to it outside of the CLI. No luck.Factory reset has been performed between attempts to make sure there is no funky config left.
Hi Flavio,Yes, the console port has been tried (USB-serial) for Day 0 setup after exhausting the options on the regular ports. (Still would like to know why this is not working.)After configuring the device, it remains inaccessible.
