Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Ok, maybe this is simple issue or a limitation, I have a 5508 wireless controller that is only used for home users with OEAP access points. When using a OEAP 600 we can chain the phone and pc on the same port with no issue, on a OEAP 1810 the phone g...
Hi, I have a Cisco WLC 5508 I am setting up and we are using it only for OEAP devices for home users. It seems that the OEAP devices (600 series and 1810) will only successfully connect if the management interface is the one that is internet facing. ...
This question is for people that use Cisco Prime's plug and play to configure switches at remote sites, this is Prime WITHOUT using the APICS-EM. I don't have much issue with pre-provisioning the new switch in prime, the question I have is what port ...
I should mention that on the 1810 OEAP if the phone is on port 1 and pc on port 2, they both get a corporate IP and work fine, maybe it is a limitation of the 1810?
Thanks Rasika, I will give this a try. I think the only part I need is to restrict the traffic to Capwap ports you mentioned and make sure that inside trust traffic can reach the management on 443. I will let you know how I make out.
