Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I have the topology with two orphan devices that are on different vlans but vpc peers would never seem to sync arp over cfsoip and hence the ping from one orphan device to another isn't working. Is it expected scenario? Config attached. The SW1 h...
Hi, I found this command in the official Cisco configuration guide for vxlan. system vlan nve-overlay idFor scale environments, the VLAN IDs related to the VRF and Layer-3 VNI (L3VNI) must be reserved with the system vlan nve-overlay id command.Howe...
Hello everyone,When designing the data center with vxlan evpn we're trying to look for the right models for nexus switches. So for spines, we would originally get a switch with a tomahawk chip, for border leaf with Jericho, and for TOR leaf with a tr...
Hi,Here is the premiseLeaf 1 sends a route type 2 update with standard community to leaf 2 (border leaf) and then this /32 is redistributed into ipv4 vrf and advertised outside of EVPN fabric. The issue is with standard community, it's being stripped...
Hello everyone,Can someone please provide a list of Nexus switches that support ESI Multihoming (1&4 evpn routes) for LACP?We have 9318yc-fx and it's not supported on our platform.Thanks!
Hi Pavel,Ping from H1 to H2 fails. I can ping the gateways:I can see the MAC and IP addresses in l2rib. Meaning they are advertised and imported correctly And I see the pings on the link among spines and leaves but these icmp requests are never being...
We would go with Cisco 9336-fx2 for spines, and Cisco 93180yx-fx3 for leaves but we're unsure what to get for Border leaves. Thanks for the reply though.
Hello, Lawhsed,Here is what I've found out:In terms of layer 2 bridging and without suppressing arp there is no difference. The difference is when we start doing routing.
