Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I have two switches where layer 3 mode is enabled on both. I have created two VLANs (10 and 20) on the two switches and configured a static route to reach each VLAN. And then assigned the VLANs to Switchports but I am still unable to let the tw...
Hello, We have cisco sg300 switches (switched network/ LAN), and we are collecting interface statistics data such as in/out octet, unicast, multicast and broadcast for each switch and each port of the switch.Can we detect sniffing attack on the switc...
Could you kindly share a guide or direct me to a resource that provides comprehensive instructions for configuring the two switches to enable successful inter-VLAN routing? Your assistance in this matter would be greatly appreciated.
1. I need to detect if the port spanned.2. can you explain more pleaseAnd if we collect switch data (in/out octet, unicast, multicast and broadcast) and plot them in a graph. Then we monitor this graphs and observe data changes can we figure out if w...
can you please explain more for us. we searched about this topic and the result was that when data sniffing occurs an increase in data traffic appears which may help us detect it. Is this possible ?
