Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am trying to configure a banking enterprise network. Just started. So, I put a switch in each department. A specific vlan for each. I have configured the layer 3 switch ports with vlan 10 and vlan 20. and given them ip addresses as well. And I am a...
I am currently trying to set up the gigabit ports. I need to have atleast 40 end devices. But these 2 ip addresses i entered for the gigabit ports are overlapping% 192.168.1.0 overlaps with GigabitEthernet0/0Can anyone explain why this is how to fox...
Sorry about the late reply. Been busy working on the assignment. If you don't mind. Will you be able to take a look one last time at the HSRP configuration of the the two routers on the very left. They dont seem to communicate and both stays active.
Understood. Is there any reason you didn't do it on vlan 10 as well? What should I do now to make it so that the pcs can communicate, since they cant ping each other anymore.
Ah. I see. I figured out how to do HSRP with routers. But I cant seem to find any scenario to learn from thats similar to mine. (redundancy with layer 3 switch)
Next step is to implement redundancy. I did the same configurations on the second layer 3 switch, and trunked the ports connecting them both. It pings, but when I go into simulation mode and send a packet, it shows the packet making unnecessary trave...
Oooo. I forgot to actually create the vlan riiight. I see. That was super helpful. Thank you. If I have more questions regarding this assignment but its not on the same topic (intervlan routing), should i make another post or can i reply here?
