Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I set up P2 a couple of weeks ago. I used a DSL static IP Internet connection IN1. My hope was to be able to access R2 and the remote VLANs 1,2,3,4 from H1 once I got home?.. Not working out so well?. Losing sleep over this one?. I can get full acces...
Feb 11 19:33:59.035: %SW_MATM-4-MACFLAP_NOTIF: Host 2c27.d716.a867 in vlan 1 is flapping between port Gi0/15 and port Gi0/16Feb 11 19:34:03.724: %SW_MATM-4-MACFLAP_NOTIF: Host d8d3.8569.c97d in vlan 1 is flapping between port Gi0/11 and port Gi0/12Fe...
hello Jon,Still no joy, spent most of Saturday messing around with various configs but was still unable to get to my test laptop with the default gateway pointing to IN2.... Here is the drawing of the test lab I set up locally. I didn't want to break...
Here are the definitions I could find. and If I understand the concept... P2 will set the source address of my telnet session to R2 to be something on the VLAN 1 network. and when R2 responds P2 will NAT the correct destination back onto the packet? ...
Any changes to R2 will be very difficult to make as this router is in Mexico and there is no technical staff available to make any changes.... I should have added the routes when I dropped in the 506... DOH! The ideal would be to get a single telnet...
