Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello
I have a problem that i am receiving prefix on a router with ospf from 2 direction ( primary/ backup ) devices and it should be preferred using metric in the redistribution statement as below
the problem that the metric isn't seen in the route...
Hello,
I am having a problem that BGP when it become down due to any physical issue didn't become up again due to NAT however i can't see any relation as there is no conflict in the Ips used in the ACL with the WAN ip used
however when we added a s...
Hello,
i have a router C1111 and need to connect it to 2 nexus switches using VPC
I checked most of the videos and searches which show the configuration from nexus switch side
i tried to configure the router by the same way but for example can’t fi...
Hi all, i need any help on the below problem as i have c800 router using it as a switch. All interfaces is configured with dot1x configuration with voice vlan as below switchport access vlan 800switchport voice vlan 100no ip addressauthentication ...
these routes should be external but 10.0.0.0/8 seems to have a problem due to the other redistribute ospf 2 as i checked another prefix inside ospf 2 in the route map Network and found it in R3 seen from 2 paths ( the same behavior 10.0.0.0/8)
if yo...
yes i tried to check another prefixes that should be learnt from the other ospf Process and found the same behavior that load balancing is done so i will need to make change on the redistribute ospf 2 to take the same metric as
redistribute bgp
ok i will try to change primary router to be E1 and check but in this case i think there is no need for metric 100/ metric 200
i will depend only on the Type E1 ( primary) /secondary Default which will be E2 correct ?
I tried to check the routing table but didn't see any other route with metric 2 just other subnets from BGP and also i checked OSPF database to be sure if i am receiving this subnet from other place or not but in the database i just find it on R1/ R2...
