Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all
I am trying to configure ipse tunnel to remote site (ASA5505) from a ISR router 4331 with source NAT. The IPSEC part alone is working, but when I add source NAT functionality, it won´t work. Here is my config:
Any help would be appreciated!
!
...
Hi everyoneI am trying a to establish IPSEC ikev1 tunnel mellem a ASA with default parameters and Cisco router. When I ping from both side of LAN behinde ASA or the router the tunnel comes up. Both phase 1 and 2 compleated.But output "show crypto IPS...
I have a IPSEC tunnel between site A “4331 router” and site B “C800 router”. And a Win10 machine are connected to LAN site on both behind both router. Ping from site A to machine behind router B brings the tunnel up and debug for isakmp and ipsec sho...
Hi
I am running a customer-oriented client / server application. And I need to, when the client starts session by allowed ACL to the server with dst. tcp/1099 port than my firewall should open subsequently some high-end tcp ports dynamically in the s...
Hello dear Masoud
Tanks a lot for your very good description of ip nat in your posts. I have a ipsec tunnel that using both ip nat inside source and destination in Cisco ASA. I would to convert those ip nat configuration from ASA to ISR 4331 route...
It was actually a symmetric routing in customer ISP infrastrcture that caused the problem, but they have not solved it yet. And way many tank, It was pointed out in the right direction !!
