Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Is it possible to have two different L3 BDs with devices connecting the same vlan ID ? see example below.VRF: SameDomain : Same physical domainVlan pool : same poolEPG 1 :BD 1 :L3 : 10.10.10.0/24End device vlan ID : 100EPG 2 :BD 2 :L3 : 20.20.20.0/...
Hello, I have just added a standby controller (apic version 6) to a 3 node active apic cluster. under the standby controllers section, I can see everything seems okay, when going into the node 21, I see the operational state of the standby controller...
Hello,
I have a upgraded one our public facing routers from 2951 to ASR1001-X. Since then I have connectivity issues with one of our BGP neighbors. The problem is, no return traffic is received from the neighbour.
- BGP peering works
- Receiving ex...
thanks @andreas.blum for your answer, I am not sure fully understand your answer here. - Multiple L3 subnets in a BD is a good shout - but DHCP helper can only be enabled on the primary subnet aka pervasive gateway - I have already migrated the netw...
Hello,Let me try to understand and summarize your issues. Issue 1 - APICs not joining the cluster via the CIMC network1. Does the management network of APIC 1 have connectivity to the CIMC networks of the other APICs? I assume this is through the ACI...
If I understand correctly, you wanted 1. configure OOB management interface descriptions for nodes via the GUI 2. and will be able to see the description for "show int description" command SSH access to node i.e. leaf or spine ? if so, please follow...
