Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,One of my clients wants to disable SNMP traps for access ports linkup and linkdown (F0532) events. I tried by "unselecting" Access Port (eqpt.LeafP) under SNMP tab of the monitoring policy is applied to the policy group of the leaf access por...
Hi all, I have the following situation:I want to create an L3out (SVI) and add a BGP peering. Since the SVI consists of both the 2 VPCs I add a new path to the Interface profile of the L3Out, with the same ip addressing scheme.My problem is how to cr...
Hi all,I am trying to configure 2 static bindings for two EGPs belonging to two different Tenant, but it does not work as expected.Here the recap of the situation:Tenant A -> EPG vl_100 -> Leaf 111 -> port eth1/5 -> vlan 100Tenant B -> EPG vl_100 -> ...
Hi all,wath does system-link-level-1G-auto do?I know that ACI put duplex always as full. But in this case, what will be the speed?I tried with a 1G connection that I have and I create a new LLP with Auto Neg On and Speed 100Mbps and I see that the Sp...
Hi all, next week I will migrate a FEX from legacy to ACI and so I have to configure Access and Tenant policies. For the Access policies is ok, I found many recources online and I am pretty confident the configuration is working. Unfortunatley I have...
Hi @balaji.bandi ,ACI version is 6.0(7).I followed the guide in the link to setup SNMP. But, then I was asked to remove access ports traps, but this does not work..
HI @MHM Cisco World, sorry for my late reply but I have been busy, too. I am still waiting for doing some test in a lab regarding all the stuff wrote in this thread. Did you read all? What do you think?thanks,Irenof
The test I performed does not use VPC, but only single interfaces. I just tested configuring a BGP peer profile under the interface that is not connetected to the router. I think that it should work also in VPC context, but at the moment it is no a t...
If the VPC where I "binded" the BPG peer goes down, what hapen to the session? I think that since there is the other VPC in the SVI, nothing happen. Even if the BGP peering is under the other VPC...I only tested this, with a SVI with two interfaces:...
Hi M02@rt37,I tried creating two equal BGP peers under both VPC paths (VPC10 enad VPC20):and ACI creates the same neigh conf twice under each leaf (i.e. two equal bgp neighs under leaf 101and two equal bgp neighs under leaf 102). The actual BGP sessi...
