Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Does anyone knows if there is an equivalent command to bandwidth qos-reference for subinterfaces on IOS-XE Version 15.5(2)S1c? I can use it on tunnel interfaces but not on subinterfaces.
IOS-XE Version 15.5(2)S1c
(config-subif)#bandwidth ? <1-10000...
Hello Everyone,First of all I would like to state that I'm far from being a QoS especialist. I need someone to shed some light on the following issue;The below configuration is applied to a WAN link, and the interface is dropping packets on the Defau...
Hello,Can anyone point me in the right direction about the following situation?We have a router that is receiving about 400-430Mbps of traffic in its LAN interface, but is only transmiting around 320-350Mbps over the WAN link. There are no drops in t...
Hello Everyone,I have a problem with a client complaining about assymmetric routing, I already performed a traceroute from source to destination and backward and for me all seems to be fine, but now the client is complaining about the hops 2 and 3 w...
Hello Paul,I've read you're explanation but still there are details that I don't understand. I just had the same issue and I was able to replicate it on the lab. The topology is very simple SW1(MSTP priority 0 for MSTI0 and priority 4096 for MSTI1(vl...
Thanks a lot to both Fischer and Joseph, will try to play with the WRED thresholds and see what happen, make a lot of sense since the graphs are showing peaks of transitory traffic and also peaks of transitory latency.
This is weird, I was reading about how to monitor WRED and this is the outputs that I got#sh queueing random-detectCurrent random-detect configuration:#sh queue fastEthernet 0/1'Show queue' not supported with FIFO queueing.#sh int fa0/1 | in Queueing...
