About Ruben Leal

Ruben Leal · 03-11-2016

Does anyone knows if there is an equivalent command to bandwidth qos-reference for subinterfaces on IOS-XE Version 15.5(2)S1c? I can use it on tunnel interfaces but not on subinterfaces. IOS-XE Version 15.5(2)S1c (config-subif)#bandwidth ? <1-10000...

Ruben Leal · 08-21-2013

Hello Everyone,First of all I would like to state that I'm far from being a QoS especialist. I need someone to shed some light on the following issue;The below configuration is applied to a WAN link, and the interface is dropping packets on the Defau...

Ruben Leal · 01-23-2013

Hello,Can anyone point me in the right direction about the following situation?We have a router that is receiving about 400-430Mbps of traffic in its LAN interface, but is only transmiting around 320-350Mbps over the WAN link. There are no drops in t...

Ruben Leal · 10-02-2012

Hello Everyone,I have a problem with a client complaining about assymmetric routing, I already performed a traceroute from source to destination and backward and for me all seems to be fine, but now the client is complaining about the hops 2 and 3 w...

Ruben Leal · 09-08-2015

You're right, I can confirm that lowering all VLANs priorities but 1 on SW2 fixed the issue.Thank you so much for your prompt response

Ruben Leal · 09-08-2015

Hello Paul,I've read you're explanation but still there are details that I don't understand. I just had the same issue and I was able to replicate it on the lab. The topology is very simple SW1(MSTP priority 0 for MSTI0 and priority 4096 for MSTI1(vl...

Ruben Leal · 08-22-2013

Thanks a lot to both Fischer and Joseph, will try to play with the WRED thresholds and see what happen, make a lot of sense since the graphs are showing peaks of transitory traffic and also peaks of transitory latency.

Ruben Leal · 08-22-2013

This is weird, I was reading about how to monitor WRED and this is the outputs that I got#sh queueing random-detectCurrent random-detect configuration:#sh queue fastEthernet 0/1'Show queue' not supported with FIFO queueing.#sh int fa0/1 | in Queueing...

Ruben Leal · 08-22-2013

It is also happening in these two other routersCISCO2911, C2900 Software (C2900-UNIVERSALK9-M), Version 15.0(1)M6 Cisco 1841 Software (C1841-ADVIPSERVICESK9-M), Version 12.4(24)T3I thinks this is more a configuration issue.

Member Since	‎10-02-2012 01:18 PM
Date Last Visited	‎05-06-2022 12:04 AM
Posts	15

User Statistics

User Activity

Bandwidth qos-reference on IOS-XE

Interface dropping packets without reaching its full capacity

Traffic gap between LAN and WAN

Two hops with the same IP address.

You're right, I can confirm

Hello Paul,I've read you're

Interface dropping packets without reaching its full capacity

Interface dropping packets without reaching its full capacity

Interface dropping packets without reaching its full capacity