Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
If you have Dual 5GHz Radio Mode disabled on 9136 and 9178 APs, is there a way to configure them so that the second (unused) radio doesn't show as Down on the WLC homepage? When you look at the second radio, it's showing as Admin Disabled because Dua...
Thanks for the replies! Unfortunately, we don't want or need Quad Radio Mode (=dual 5GHz radio support) at the present time. These are high-density deployments, and doubling the radio count on 5GHz would be as undesirable as moving from 20MHz to 40MH...
I opened a case with Meraki support and asked them convert my 9164 AP to DNA-C mode (basically the traditional Cisco AP mode where the AP connects to a Cat9800 WLC). After a couple emails back and forth proving the AP was really mine, they converted ...
Same problem here with a Meraki 9164. I'm trying to do a 6GHz coverage bake-off between Cisco 9136, Meraki 9164, and Aruba 635 APs. Problem is, the 9164 doesn't advertise the site-survey SSID on 6GHz when it's in survey mode. This same behavior was i...
Finally I have something to contribute here!
Microsemi's PD-9501GO-ET (datasheet and installation guide attached) is the improved version of the unit Cisco specifies on their datasheet (AIR-PWRINJ-60RGD1). Here are the part numbers for that inj...
