Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I have been troubleshooting this problem for 8 hours and have not figured it out yet. Basically, I have a 2811 where the FA0/0 keeps dropping packets at the interface now andthen seemingly when traffic tends to burst but anything over 5 megs a...
Hello,I've got a 3845 here with 12.4. My understanding was that the "tunnel bandwidth transmit" was used to adjustthe outgoing traffic of a tunnel beyond a default of 8000 kbps.However, I found that my Tunnel is actually processing outgoing traffic ...
I'll add those right now and try .. Thanks.It's towards the end of the day here so traffic has gone down so the errors are not happening anymore. However, I decided to look at debug ip icmp and I am getting:ICMP: dst (1.2.3.4) frag. needed and DF se...
Hi Juergen,Yes, it's not a duplex / speed issue and I have the statisitics for CPU processes in my original post.We may look at adjusting the MSS to 1024 or lower. And I do agree, clearing the DF bit may be a good idea.CEF is running.Thank you for t...
Well, the MTU is low because there's actually 2 Tunnels - there's the the GRE Tunnel but inside the GRE Tunnel is another military type grade tunnel.. we had issues with fragmentation (ICMP Discovery)I thought about that... but why would ... hmmm......
I don't have time to type that much right now but best thing is to look at config examples on theCisco website. You're right though - Cisco has dwelled on command lines for the longest timeand it's more complicated than it needs to be. I've setup q...
