Cleber,You have to contact cisco who will access inside your node with StrataCom level and they will issue the command cnfswfunc. (output below)Index Status Function1 Disabled Data Frame Multiplexing2 Disabled Adaptive Voice3 Enabled...
The UFM-U/C is in standy mode when there are no resources configured.If the card is UFM-U you have to activate a port ( upport ).If the card is a UFM-C you have to:-activate a line (upln)(the card will be active after this)-add a logical port (addpor...
Hi cesar,In our network we burned all the BMX with the firmware MFW and it has run fine for the past 5 months. We have the same firmware for the BCC.Unfortunately I don't have PNNI so I can't tell if I don't have your same problem.By the way , give ...
Hi Cesar,What command do you issue in order to check how many conns free you still have?Do you have partition in your BPX?What is the firmware level of yours BXM and BCC? Have you already checked in the bugtool whether this is a bug?Regards,Giuseppe