Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, I am testing RLFA in a ring with ASR903, ME3600X and ASR9K. I am trying to configure RLFA in ASR903 (15.3(3)S), but it´s not working out, I didn´t even get Repair Path. The config is below:router ospf 1 router-id 10.0.0.5 ispf fast-reroute p...
Please, I am trying to configure two AP-management interfaces to accept CAPWAP on different ports using the option "Enable Dynamic AP Management". One of them uses public ip address. However, I getting the message "Ignoring discovery request received...
Please, I need a help on PFR routing.I am using a 2900 (15.2(2)T) and I am getting these messages:PFR PIRO: No parent found, network 10.10.2.1 interface Tunnel1PFR PIRO: No parent found, network 10.10.2.1/32OER BR ACTIVE PROBE: Parent route not found...
please, I am configuring a 10000 and I need to add "Acct-Input-Gigawords" and "Acct-Output-Gigawords" in the accounting register. How can I configure that ?Thanks in advance !Cleber
Please, I need to configure the ingress QoS per port, but I just saw the the commands "mls qos srr-queue input" in global config not available per port. The manual said that there 2 queues to receive traffic before to go in the internal ring. Anyone ...
Thanks for answering. I think that join is handled by AP management interface and mgmt interface usually is used. But, as the manual says, it´s possible to have more than one interface working as AP management (there is a option in interface configur...
One related question: in 837 there is virtual AUX (whhere the CON can work as AUX), but is this case will I lost the console port to do management, for example ?Thanks,Cleber
