Hi guys!!
I've analyzing this case:
I need to set the address on interface p2 of R1 to use as gateway for the /24 networks on SW2
- Can not plug SW2 directly to SW1
- Can not use VLANs
- Using only Static Route (no protocol)
[10.10.0.0/24] -...
I'm analyzing as new addressing scheme, the idea is to set 10.A.B.node schema.
10: organization private network
A: brach (internal organization site / geographical network)
B: several subnet for each branch
But in some cases level/groups of subne...
Not working for me, using a Cisco 1941:
ip address 10.10.9.0 255.255.255.0 secondary
^
% Invalid input detected at '^' marker.
But, this is the habitual way to solve this? we need to enter 247 secondary interface...
Ummm ... I solve this with only one address 10.10.0.0 255.255.248.0, for p1, but p2 can't be resumed on one address, then I take your idea and try add secondary ips grouping the SW2 networks ... I'm going to try!!
But, this is the habitual way to sol...
No, I don't know how I could do that. But yes the problem is the overlapping on p1 and p2, that are limiting the range covered on p2 mask. p1 is in /21 let communication with all networks on SW1 from 10.10.0.0/24 to 10.10.7.0/24. But p2 can't be /16 ...
