Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
As of 1:30 yesterday, no clients can authenticate to my LWAPP Access points. I'm getting this message in the trap logs on my 4404:Client Excluded: MACAddress:00:90:4b:86:23:94 Base Radio MAC :00:17:df:7f:c8:60 Slot: 0 Reason:802.1x Authentication fai...
I was playing around with the config of a Cisco 1030 from my WLC, and set the mode to "bridge". And hit the Save button. Now the 1030 endlessly reboots itself, and the WLC no longer sees it. Is there a way to reset to factory defaults without the ...
For cost reasons, we desire to have individual VPN clients on a remote office LAN for connecting to corporate network. For example, if the office has a DSL connection to the Internet, where the (cheap) DSL router is running NAT, only one client can ...
I had several issues, and resolved them. First is the antenna type; you must use antennas that are tuned to 5Ghz (802.11a), not 2.4Gz, since the 1030s only use the A radio for backhaul.Second is the config: you must add RAP and MAP MAC addresses to ...
Given the older glass, and only 200', a Yagi is overkill. Should work, but I'd bet you could use any antenna, including the standard rubber duck. 'Course, after the temporary situation ends, it'll be nice to have spare Yagi's laying around...
That was it. I had two RADIUS servers configured in the 4404 WLC. For whatever reason, it started using the 2nd one in the list, which I had forgotten to enable PEAP for. Amazing that I went this long withuot realizing the two RADIUS servers weren...
