Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HelloI have a network at work as shown in the attached diagram.Region 1 is in the MSTPRegion 2 is in the MSTPand it is connected by a switch in the RSTP.The scheme is simplified, of course i real , Region 1 I have 20 switches and Region 2 I have 50 s...
Hello I have problem with loop guard and flapping port.Short info about my network .I have 44 switch connect in spanning tree MSTP. I was configure 3 instances .I deleted the ip switch addresses and changed the vlan names. Vlan X is from instance 1 ...
HelloI did as you wrote in the second case, i.e. CST switch is in the R1 regionWhen I turn on the ports between region R1 and RSTP everything is OK (Ports P1, P2, P5, P6)When I connect the secound port from the R2 region, P3(first) next P7 gets the ...
HelloI understand that this configuration for a switch from the MSTP region and what about a switch in RSTP, an additional specific configuration is needed.And what configuration should be between two regions MSTP (in my diagram point Z1 to Z4)I set...
Hello"Not forgetting you have the rstp switch the root for both mst regions so then your in the realms of negating pvst simulation scenarios"And you can develop what that means for me? Maybe some special configuration should still be there. I also tr...
I do, for example, the RELOAD command, for example after uploading the new fimware.Or the second situation is to take the power off the switch for maintenance work
Hello "min 25, the expert talk about the add of VLAN and it effect on MST."I understand that you are suggesting that must be 25 instances? Did I understand you well?Thanks for the video, I am analyzing them, I will let you know when I have more ques...
