Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Community, We use ASR9010 with 04 PM in 2 PEM.Could you tell me if the ASR9010 PEM 0;1 device has specific power supply requirements for a particular line card slot?
Hi all,I make 1 monitor session on ASR9K, with source int te0/2/0/0, and 12 sub-interface of int te0/2/0/0, dest int Gi 0/6/0/0But, monitor session is working with sub-interface, show monitor session counter dont have rx, tx in physical int te0/2/0/0...
You can install the new ios in 1 RSP active. ( Take off RSP standby )In the case need rollback to old IOS, take off the RSP active and insert RSP standby back to boxThe router will come up with the IOS old ( the IOS on the RSP standby card)
I find the answer to this issue.The span port will capture traffic on the port, but the span has just captured the port to have real traffic. In this case, The physical interface don't have real traffic, the traffic in sub-bundle
Hi BB,Yes, the sub-inter has RX, Tx. I don't know why the physical interface doesn't have Rx, TX.This is output of the command:RP/0/RSP0/CPU0:PE_ASR9#sh monitor-session test status Mon Dec 6 10:20:49.754 GMTMonitor-session testDestination interface G...
