Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I will have an ASA5505 with IP phones on both the inside and outside interfaces. All subnets on either side of the firewall will be using a private IP address scheme and their will be no internet access available via this firewall. The question I hav...
As a packet travels through the firewall (inside => outside) is it possible to NAT the source IP (with the outside interface of the FW) and translate the destination IP? Also, the destination IP (translated IP) would need a static route in the firewa...
I've setup a VTI on two 2821 routers which both have ZFW deployed on them. Without ZFW on the VTI works between the two routers and all traffic passes freely. When I turn on ZFW (basic FW using the wizard) no traffic flows over the VTI. The VTI is up...
My question has to do with how to failover over between our primary WAN links (two T1's that terminate on the same router) and a VPN tunnel (on a different router) if only one of our T1's go down. The two T1's and the VPN tunnel are running OSPF and ...
Kusankar,Thanks for your response. To clarify, by turning NAT control off this will allow connections to originate on the outside and terminate on the inside providing:• Appropriate routing is in place on either side of the firewall.• ACL's are ...
