Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,I'm trying to log commands with my ACS 4.2 version, but the cmd section remains empty. Can someone help me to figure out why the commands are not logged?infrastructure is configured for accounting as follows:aaa accounting exec default stop-on...
Hi all,I have an issue bringing up my RMA'd primary ASA unit.So what happened so far:1. primary unit failed2. secondary took over and is now secondary - active (as per sh fail)2. requested RMA at Cisco3. got ASA and checked that Lic (SSL), OS (8.2.2)...
Hi ExpertsI heard about the capability that the AnyConnect 2.4.x is able to reconnect a previous DTLS session without re-entering the xauth credentials? Can any one tell me were this feature can be enabled on the ASA with 8.2.2 code? I'm looking as w...
Hi Varun,I was able to put in the commands you mentioned and afterwards i fired up the ASA with all cables plugged in, and synchronisation started without any issues.After some time i did a failover active on the standby unit to make it the active on...
Hi Varun,Thanks for your help!I will modify or extend my config on the primary ASA without all the cables plugged-in.Afterwards it should be straight forward to fire up the primary unit and the secondary will replicate its config to the primary u...
Hi Varun,Thanks for catching-up this thread.Here you go:sh run fail on secondary - active:failoverfailover lan unit secondaryfailover lan interface Failover Ethernet0/3failover key *****failover link Failover Ethernet0/3failover interface ip Failover...
Hi Simone1. if you're using outbound vpn (ipsec) to a headend located in the internet you'll need to open udp 500 for isakmp and udp 4500 for nat-t and IPsec over TCP will be using tcp 10000 if cisco is used.2. you'll need to add the following to you...
