Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello:MY problem is two cat6509 run hsrp authentication no work.ADD other cat6500 setting standby xxx priority 150 "sh stan" is R3 standby?R1 interface Vlanxx ip address xxx.xxx.xxx.1 255.255.255.0 no ip redirects no ip unreachables standby xxx p...
MY E-mail address: ricosiu@hkem.comI have used the versions of CatOS 6.2(2a) After auto reboot , it will show the following messages.Why does it show those messages? Please give me some suggestions. sh logNetwork Management Processor (ACTIVE NMP) ...
HiGo to CCM ->selected phone number->Product Specific Configuration->Gratuitous ARP (set disable)->PC Voice Vlan Access (set disable)But not slove 7910 this is a face problem...ricosiu
Dear all I add ACl at interface.But logging this message.136.136.1.1 is a router interface.Why source interface is router ip not is PC address.%SEC-6-IPACCESSLOGDP: list 2302 denied icmp 136.136.1.1 -> 151.199.214.230 (3/13), 2 packets%SEC-6-IPACCE...
I Try test debug HSRP :*Dec 3 11:32:28.583 HKT: SB252: Vl252 Hello in r1 Active pri 200 ip xxx(r1)*Dec 3 11:32:29.139 HKT: SB252: Vl252 Hello in r3 Standby pri 150 ip xxx(r3)R1 ,R2 ,R3 is trunking allowed all vlan.So R3 said is standby router....
