Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Folks, Would appreciate any help with this virtual lab environmentpasted running config along with the debug output............please scroll downi am doubting the topology network(vmware) itself csra(conf-serv-sip)#csra(conf-serv-sip)#do sh...
i understand what you mean by one cube only. the cube has 3 interfaces. 2 were talking about but the calls fail still.i can only source one interface on the cube configuration......Am i correct ?with the topology as i shared before i still get calls ...
Now you’ve cleared my doubt about this. What I’m doing right now itself (in the next few minutes) creating a new cube to connect/bind/source.To extend the topology in an ideal way, the call flow will be likeJabberA -> cmA -> cubeA -> cubePSTN -> cmPS...
These are 2 separate clusters. One’s playing pstn role let’s say 911 destination for the call made from jabber site-A .JabberA—>cmA—>G2cube-g1–>cmPSTN—>CIPCpstnCalls show state dead on the cube itself. Not reaching to the pstn cm.
I’m currently using a single cube between 2 CUCMs. If this won’t work.Should I have to have 2 cubes between site A and the pstn?Hoping you’ve seen the diagram I built to give an idea about the topology?
