Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi everyone!I tried config LACP on two switch Layer 3 by Pnetlab as below:but it just show error:*Feb 17 08:09:55.391: %EC-5-L3DONTBNDL2: Et0/1 suspended: LACP currently not enabled on the remote port.*Feb 17 08:09:55.652: %EC-5-L3DONTBNDL2: Et0/0 su...
Hi everyone,Wish you have anice day!I have a lab as picture below. The lab request R5 just learn 1 row route 10.0.0.0/8 from ABR R1. How can I summary on R1 all subnets 10.0.0.0/8 behind it, I try configure on R1(config-router)#area 0 range 10.0.0.0 ...
Hmm,But why those switchs running at mode layer 2 it's support running both LACP,PAgP and then enable layer 3 it just support PAgP. I found others IOS Switch L2/L3 but it just the same error, eve ng and Pnetlab just support limited ios cisco not at a...
The lab request R5 just see one row route 10.0.0.0/8 learn from R1, i try summary on R1 it just summary subnets 10.x.x.x form area 0, not summary tolltaly subnets 10.x.x.x form area 0,2,3 like picture.