About marekp222

marekp222 · 01-06-2016

Guys, I need help with connecting Cisco 2960x with HP 2530 switch. When I connect those two switches using crossover cable i get the following error message: Jan 6 15:35:52.232: %SPANTREE-7-RECV_1Q_NON_TRUNK: Received 802.1Q BPDU on non trunk Gigab...

marekp222 · 01-07-2016

JDGranger, single crossover or patch and the following configuration on the Cisco switch would be enough to create a uplink between Cisco and HP switches, right? !interface GigabitEthernet1/0/25 switchport mode trunk!Thanks for all your help

marekp222 · 01-07-2016

Finally I got it to work, the trunk/channel between HP and Cisco is up and running; however, I'm not sure why it does work in different location. Location A: Config from HP: interface 49 name "Trunk Trk1 to ga-swcomm01cisco" no lacpexitinterface ...

marekp222 · 01-06-2016

Hi, HP side is very simple as shown below: hostname "hatdry-copyroom01"no telnet-serverno web-managementweb-management sslsnmp-server community "public" unrestrictedvlan 1 name "DEFAULT_VLAN" untagged 1-52 ip address 10.128.1.109 255.255.0.0 ...

marekp222 · 01-06-2016

Hi, You are absolutely right, when I disable spanning-tree on vlan 1, the connection between two switches is fine. Q1. What is the proper way uplinking Cisco and HP switch? Is single crossover cable enough or LACP channel between Cisco and HP is requ...

Member Since	‎01-06-2016 07:32 AM
Date Last Visited	‎08-18-2017 03:54 AM
Posts	5

User Statistics

User Activity

Uplink Cisco 2960x with HP 2530 switch

JDGranger, single crossover

Finally I got it to work, the

Hi,

Hi,