Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Admittedly, I am not very knowledgeable about spanning tree... and I'm being unable to sort out a basic scenario because of it, and I'm unsure whether it is a behavior related to the small business switches and/or 300 series only.
Please take a loo...
Hello,
I just want to setup a couple of vlans that are going to provide dynamic IP addresses to some PCs directly connected.
Therefore I have created two vlans, two dhcp pools, and it works. Now I want to restrict access, in L2 I do it by means of ma...
- from switch do: ping <vlan_XYZ--interface_ip_address> source <vlan_10-interface_ip_address> count 10
If it goes everytime you have already inter vlan IP switching.
- What vlan is your workstation located at ?
from switch do:
show arp (look for you...
Effectively, you need more cooperation from third party provider. At least you have to take a look at the configuration of one of the hosts in 1841 router vlan 13 (if there are any).
It is not clear why you need the router in L3. what else are you a...
Just a little comment though. By default OSs send its traffic untagged, but you can indeed configure the vlan tagging option in the specific host network adapter properties or in the Operating system (i.e windows registry).
So you could set the port...
Thank you for your response, may God Bless you!
Effectively if I remove the cable in ge10 L3 switch I will recover that port. as it was seeing a duplicate path towards the router as you said.
- However, If as I said, what I want to do is to have se...
go on CLI (serial cable/ Serial cable to USB / console cable / or connect via the IP address you are reaching the GUI from Windows cmd: telnet <ip> or use a ssh client---- I think telnet is enabled by default, if not enable via GUI on Security->TCP/U...
