Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,
Environment: WLC 5520 version 8.5.161.0.
I have problem about Client connected SSID and It's can't obtain DHCP then this Wi-Fi status "no internet"
Example:
2 SSID: A and B [WLAN config same interface VLAN Identifier 152]
1 SSID: C [WLAN conf...
Hello Everyone, I connect between SPINE and Leaf by mesh. but1.Sometime On Port Spine:UP while on Port Leaf:DOWN2.Some Port:UP and just 3s, it's turn down. Could you suggest to me, please Thanks you.
Hello Everyone, I have a problem, I download APIC VM Simulator ver. 5.2.1g, I config IP, Default gateway and Password only.And I set Promiscuous mode to "Accept" on vSwitch but I can't access GUI or PING to this VM.[ FYI: I test APIC VM Simulator and...
TCA: CRC Align Errors current value(eqptIngrErrPkts5min:crcLast) value 0% fell below threshold 1% I'm beginner for ACI. I connected mesh SPINE [Int1/1] and Leaf [eth1/60] between 40G QSFP+ and Not config anything.It's show on APIC: [Switching State: ...
