About ajay.videkar

ajay.videkar · 02-14-2022

Hey guys, I am trying to get a link at 50G with fec_type = standard.My steps are as follow - enable conf tcontroller Optics 0/0/0/20no breakout 4x10no breakout 4x25breakout 2x50commitexitinterface FiftyGigE 0/0/0/20fec standardno shutdowncommitexit I...

ajay.videkar · 02-08-2022

Hi All, I had a few questions regarding setting negotiation to auto.I currently have setup a HundredGigE on one of the port, and this is what it looks like - ladjfcisco5011#show interfaces HundredGigE 0/0/0/21Tue Feb 8 23:32:06.777 UTCHundredGigE0/0/...

ajay.videkar · 02-14-2022

Hi Georg, Appreicate the prompt response. So, I did configure ports 0/0/0/20/0 and 0/0/0/20/1 to FiftyGigE. I entered both the new breakouts and configured them fec standard, no shutdown and commit. 1. Before committing the settings (setting fec, and...

ajay.videkar · 02-14-2022

Yes, I am aware of that. So in my case, since it's port 20, it breaks out to 0/0/0/20/1 and 0/0/0/20/2. Do I configure these new breakout ports? (Re-iterating) 1. Is there a way to check the current firmware version of the switch?2. Also, is there a ...

ajay.videkar · 02-08-2022

Appreciate the prompt reply.Here's what I get after running the commands -RP/0/RP0/CPU0:ladjfcisco5011#conf terminalWed Feb 9 00:12:53.088 UTCRP/0/RP0/CPU0:ladjfcisco5011(config)#show run int HundredGigE 0/0/0/21Wed Feb 9 00:13:05.222 UTCinterface Hu...

Member Since	‎02-08-2022 03:53 PM
Date Last Visited	‎02-22-2022 06:13 PM
Posts	5

User Statistics

User Activity

Cisco NCS5011 Series switch

Cisco NCS5011 Switch - 32

Re: Cisco NCS5011 Series switch

Re: Cisco NCS5011 Series switch

Re: Cisco NCS5011 Switch - 32