Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello there,I've been using 2900 series switches which show these counters#show int count errors Port Align-Err FCS-Err Xmit-Err Rcv-Err UnderSize OutDiscardsPort Single-Col Multi-Col Late-Col Excess-Col Carri-Sen Runts Giants however we have a few 9...
We have had a new building cabled and i don't trust the test results given to us by the cabler.We have over 2000 ports via many stacks of 2960x's a spot check via the TDR command on ports that are connecting at 100 and should be 1000 are showing brok...
this is the closest i got sho interfaces | i Ethernet[0-9]| giants It outputs the name of the port and the line with the giants on it.I triedsho interfaces | i Ethernet[0-9]| [^0] giantswhich i thought would show line that didn't have 0 giants but it...
Thanks Reza,yup, that was the closest i got too. i'm lucky in that i know which interfaces i suspect will have the giants. It was so much easier when they showed on the sho int count erro table.
That does show the giants error. Last clearing of "show interface" counters neverInput queue: 0/2000/0/0 (size/max/drops/flushes); Total output drops: 0Queueing strategy: fifoOutput queue: 0/40 (size/max)5 minute input rate 11000 bits/sec, 1 packets...
hmmmm, yes it's there, but not in the table. ugh. look at those giants. GigabitEthernet2/0/40 is up, line protocol is up (connected)Hardware is Gigabit Ethernet, address is 6c13.xxxx.xxxx (bia xxxxxxxxxxxxx)Description: XXXXXXXXXXXXXXXXXXXXXXXMTU 150...
i am. I don't know anything about EEM scripts, but will have a google. thanks. If i do ever find a way to automate it i'll post the script on this thread.
