Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
I'm using stack of two C2960X in L3 mode:
ZZZ-L3#sh sdm prefer The current template is "lanbase-routing" template.
I have two Vlans and I need to block traffic between them. The problem is the second vlan is located on the other switch.
So Her...
Hello,
I've just upgraded IOS (c2960x-universalk9-mz.152-2.E6.bin) on a pair of WS-C2960X-24TS-L switches and build a stack.
During the boot process, there was a message on the console that worries me a bit:
...
POST: ACT2 Authentication : End, Statu...
Hello,
We are running CUCM v.10.5, and now we need order 10 additional phones to connect them to our VoIP system.
The model we are going to buy is CP 8845.
What license should we buy for these phones?
We used to use L-CUWL-ADDON-STDK9, but isn't i...
Hello All. I need to allow traffic between webserver in dmz and mssql (Microsoft SQL Server 2008).MSSQL use dynamic port (now it is 63796) and this cannot be changed.Basically, I can allow such traffic using next configuration:access-list dmz extend...
Julio,Thank you for all your responses.
Unfortunately, "ip access-list logging interval" didn't help as well.
As I mentioned to Paul above, I'm going to either create a ticket with TAC or simply close the topic.
I was able reproduce the same issue ...
Paul,Thank you for your time.I'm going to either create a ticket with TAC or simply close the topic.
Confirm, If I use standalone C2960X switch in L3 mode then logging for "out ACL" works.
However, In my case, I'm using the stack.
Also, I was able ...
Hello Julio,.
Thank you for quick response.
Yes, I understands how to control traffic from / to the subnet associated to the vlan. Passed my CCNP a 5 years ago :).
What I'm trying to say (in a few words) is that the ACL is not showing matches for ACL...
