Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Gents, we have two ACS 4.2 for Windows. We moved to them from ACS SE 4.1. I restored all backups to ACS 4.2 and tried to setup replication, but it is not happening. I already checked through troubleshooting guide and seems like everything is configur...
What is the beast way to replicate whole ACS database between different version? We have to migrate from ACS SE v4.1 to ACS v4.2 for Windows and when I try to replicate database it says "ACS 'ITSDACS02' is running a different version of ACS - abortin...
Dear All,we are using CW LMS 3.2.If I go to Device Center I can't see any syslog message in 24-hour Syslog Message Summary. Everything shows zero. First I checked syslog file in Log folder and I could see syslog messages in this file. Then I checked ...
Dear Experts,I have strange error when updating our CW LMS 3.2. with CM 5.1.4.It gives me error saying some files are still opened (see attachment). And even if I manually kill all processes that use those files it still gives me the same error.Any i...
CW3.1 I could successfully run compliance check. I needed all switches to have bpduguard disabled on fa ports.When I start deployment for any of my 3750 switch RME successfully changes 14-15 first ports and then I can see my RME account being idle on...
Unfortunately we don't have smartnet for ACS. So I think I am unable to create a case in TAC.What is the CISCO's approach to product's bug that can't be reported due to absence of Support Contract?
Additional Info - I could make it work, but I had to remove at Master Server all SEND check-boxes in Replication Components table except Network Configuration. Replication went fine. Then I added another replication component and tested replication. ...
Thanks a lot again, Joe.Just one note - I can see syslog from switches that have KZ Timezone configured. I checked Timezone.lst file and didn't find this zone. I also tried other non standard timezone abbreviations and they all work if they are not m...
Looks like I found the reason. I imported all 400 devices yesterday and then I discovered that I could see some of the syslogs in RME.I compared configs of the devices and found out that devices that has 4 characters TIMEZONE in syslog message (eg. K...
