About Prime56

Prime56 · 04-07-2022

Hi all,I have a vpn connection setup like this.2 REMOTE SITES WITH 2 VPN CONNECTIONS remote site 1 > data center remote site 1 > remote site 2remote site 2 > data centerremote site 2 > remote site 1 I want to have my two remote sites reach the rest o...

Prime56 · 02-17-2022

Hi all, I've been having really easy success configuring my route based tunnels from ASA to ASA. One of my sites though, has its outside IP as a private IP then gets NATd by the modem etc, and sent out.I have NAT traversal enabled on both ASAs.In my ...

Prime56 · 02-16-2022

EDIT: PLEASE IGNORE. MY PRIMARY INTERNET AT THIS SITE IS DOWN. Hi all,I was going through my sites to configure these tunnels on. I get them up nice and easy with a config template paste but this one ASA just doesn't want to work. I've redone the c...

Prime56 · 02-15-2022

Hi all,I have a SA established and am trying to ping the remote tunnel interface. I have my site set to 172.16.118.1 and the remote side set to 118.2.After attempting to ping, I issue show crypto ipsec sa and I see this: #pkts encaps: 5, #pkts encryp...

Prime56 · 02-17-2022

I was doing the config remotely, and I realized that my primary outside internet connection was down.....so it was using my backup (which has a completely different public IP) so thats why it wasn't connecting

Prime56 · 02-17-2022

Why is it that everytime I post I figure the issue out?I had to contact my carrier to tell me my public IP since I didn't have access to remote machines to go online and figure it out. They gave me it, but turns out it was the wrong one.......Had a u...

Prime56 · 02-15-2022

Can we dial it back? My issue isn't sending the LAN traffic over the VPN, its pinging the directly connected VTI interface. I would like that to be successful before adding routes to route the traffic.

Prime56 · 02-15-2022

Can we dial it back? My issue isn't sending the traffic over the VPN, its pinging the directly connected VTI interface. I would like that to be successful before adding routes to route the traffic.

Prime56 · 02-15-2022

I have a default route 0.0.0.0/0 out the wan gateway

Member Since	‎02-15-2022 01:20 PM
Date Last Visited	‎04-20-2022 12:20 AM
Posts	14
Total Helpful Votes Received	20

User Statistics

User Activity

POLICY BASED VPN ACCESS LIST BREAKS PINGS

IKEV2 IPSEC VTI behind NAT - ASA to ASA - L2L

L2L IKEV2 IPSEC VTI ROUTE BASED VPN - WONT ESTABLISH - ASA 9.10(1)17

L2L IKEV2 IPSEC TUNNEL - ESTABLISHED SAs -

Re: L2L IKEV2 IPSEC VTI ROUTE BASED VPN - WONT ESTABLISH - ASA 9.10(1)

Re: IKEV2 IPSEC VTI behind NAT - ASA to ASA - L2L

Re: L2L IKEV2 IPSEC TUNNEL - ESTABLISHED SAs -

Re: L2L IKEV2 IPSEC TUNNEL - ESTABLISHED SAs -

Re: L2L IKEV2 IPSEC TUNNEL - ESTABLISHED SAs -