Dear all, to harden secure our PIX does it make sense to deploy a bridged F/W (pfSense, Astaro UTM ...) in front of the outside I/F of our PIX? Thanks in advance for any comment! Greetings, Rainer
Dear all,pls see here our setup:Configuration:
- - Catalyst 3750
- - multiple ports configured in Trunk mode running multiple VLANs
- - single 'normal' port receives untagged IP packets
Question:
how to make the Layer 3 switch to put the untagged IP...
Dear all, we are trying to establish an uplink to a Cisco 2960 (48 ports of Gb Ethernet and two 10 Gb Ethernet SFP+ ports). At the Blade site there is one IBM 10 GBE 850nm SFP+ Transceiver (CRU 44W4408) in the first slot of the CVR-X2-SFP and at...
Dear all, we are trying to recover the password of the above switch module by using the AMM 'Restore Factory Defaults' mechanism for it. The switch came up after a while with the SWICH> prompt. Then we put in the 'flash_init' command but got this mes...
David,in order to mitigate the risk that our PIX could be hacked from outsidehe wants to deploy another security device (bridged F/W) in front of it.By the way is it relatively easy to crack the PIX repectively are any intrusions well known?So long, ...
Dear srikanth!Sorry, my answer is not yet answered. I try to describe the problem in more detail. Please refer to attached drawing too. The firewall sends untagged packets to a port of the Catalyst L3 switch (the port acts as a router and has got th...
A small progress: We replaced the 10(!) Gb SFP+ Transceiver in the CVR-X2-SFP V02 converter bya 1 (ONE) Gb SFP and connected it to a 1Gb port of our 2960 switch. Now we have a link I mean there is now the green light on at the 2960 port.But still we ...
Dear Reza,excuse me I'm not an expert in the fibre cable tech but I think we used SM between the Blade's Cisco CVR-X2-SFP and the Cisco 2960 10Gb port.However do we need a LED to SC cord in this case?Best regards, Rainer
